Materials

• #15-200 Armour Etch Cream
• #60-7024 10 inch Round Plate
• #20-0436 Rub N Etch Stencil-GOD BLESS AMERICA
• #20-0402 Rub N Etch Stencil-STARS
• USA on glass DISCONTINUED. Western Font SUGGESTED
• #21-1643 Over N Over Stencil-WESTERN FONT

Additional Materials

• Burnisher or Popsicle Stick
• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Rub N Etch Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages.The technique allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously. Additionally, it enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit.
2. After preparing the glass, draw a centerline down the back. See the centerline tutorial if necessary. Turn the plate so the line is horizontal and make another centerline to divide the plate into 4 equal parts.
3. On the front of the plate, follow the Rub N Etch directions to place the America image in the center of the plate. Rub a large star up near the brim centered between the centerlines. Repeat that in each quarter of the plate. Place the S of USA on a centerline up near the brim, followed by the other letters. Follow the etching cream instructions to etch these onto the plate.
4. Rub 2 smaller stars on either side of the large stars and another USA on a centerline . Use the etching cream, as before, to etch these onto the plate. Repeat the process to etch the remaining USA letters on the rim.