Materials

• #15-0200 Armour Etch Glass Etching Cream.
• #21-1689 Over N Over Stencil-COOKIES FOR SANTA.
• #21-1668 Over N Over Stencil-EMOJI FACES.
• #21-1607 Over N Over Stencil-UPPERCASE ALPHABET.
• #21-1608 Over N Over Stencil-LOWERCASE ALPHABET.
• #60-3870 16 oz. DRINKING GLASS.

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages.The technique allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously. Additionally, it enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit.
2. This design requires the stencil be cut. While the Santa is still on the sheet, using a hobby knife, carefully cut from the outside left edge directly across the face between the eyebrows and cheeks, all the way to the hat. Cut down the edge between the hat and the beard all the way down.
3. Carefully peel the upper portion of the Santa stencil off the sheet and place onto the glass.Position the sunglasses under the eyebrows. You may need to trim the corner of the glasses as shown. Carefully peel the bottom piece of the Santa stencil off the sheet and position under the glasses. Adjust the pieces until the alignment looks correct. Press down firmly. Follow the etching cream instructions to etch the Santa onto the glass.
4. Looking through the back, place the letters around the Santa as close as possible. Begin with the last A in Santa and work backward followed by the S of swagger and go forward. See the lettering tutorial if necessary.